设为首页 | 加入收藏 | 网站地图

咨询电话:

086-0755-82816682

您现在的位置:芯片解密工程师之家 >> 芯片解密工程师专栏 >> 张工1单片机解密专栏 >> 浏览文章

AT89C5131AL芯片解密

发布时间:2010年07月02日 来源:本站原创 作者:admin 点击:

  深圳芯谷科技长期提供针对各种IC芯片、单片机、DSP芯片、FPGA芯片以及其他高难度IC提供高效解密服务,我们长期以研究所的和实验室的研究模式进行多项技术攻关,可为每一款芯片提供最具经济价值和可靠性的解密服务。
  有AT89C5131AL解密需求者请直接与我们联系:
  芯谷科技芯片解密咨询电话:86-0755-83757070
  咨询QQ:470739064
  Email:xingu2010@126.com

  AT89C5131AL Features:
  80C52X2 Core (6 Clocks per Instruction)
  – Maximum Core Frequency 48 MHz in X1 Mode, 24 MHz in X2 Mode
  – Dual Data Pointer
  – Full-duplex Enhanced UART (EUART)
  – Three 16-bit Timer/Counters: T0, T1 and T2
  – 256 Bytes of Scratchpad RAM
  16/32-Kbyte On-chip Flash EEPROM In-System Programming through USB
  – Byte and Page (128 bytes) Erase and Write
  – 100k Write Cycles
  3-KbyteFlash EEPROM for Bootloader
  – Byte and Page (128 bytes) Erase and Write
  – 100k Write Cycles
  1-Kbyte EEPROM Data (
  – Byte and Page (128 bytes) Erase and Write
  – 100k Write Cycles
  On-chip Expanded RAM (ERAM): 1024 Bytes
  Integrated Power Monitor (POR/PFD) to Supervise Internal Power Supply
  USB 1.1 and 2.0 Full Speed Compliant Module with Interrupt on Transfer Completion
  – Endpoint 0 for Control Transfers: 32-byte FIFO
  – 6 Programmable Endpoints with In or Out Directions and with Bulk, Interrupt or
  Isochronous Transfers
  Endpoint 1, 2, 3: 32-byte FIFO
  Endpoint 4, 5: 2 x 64-byte FIFO with Double Buffering (Ping-pong Mode)
  Endpoint 6: 2 x 512-byte FIFO with Double Buffering (Ping-pong Mode)
  – Suspend/Resume Interrupts
  – Power-on Reset and USB Bus Reset
  – 48 MHz DPLL for Full-speed Bus Operation
  – USB Bus Disconnection on Microcontroller Request
  5 Channels Programmable Counter Array (PCA) with 16-bit Counter, High-speed
  Output, Compare/Capture, PWM and Watchdog Timer Capabilities
  Programmable Hardware Watchdog Timer (One-time Enabled with Reset-out): 50 ms to
  6s at 4 MHz
  Keyboard Interrupt Interface on Port P1 (8 Bits)
  TWI (Two Wire Interface) 400Kbit/s
  SPI Interface (Master/Slave Mode)
  34 I/O Pins
  4 Direct-drive LED Outputs with Programmable Current Sources: 2-6-10 mA Typical
  4-level Priority Interrupt System (11 sources)
  Idle and Power-down Modes
  0 to 32 MHz On-chip Oscillator with Analog PLL for 48 MHz Synthesis
  Industrial Temperature Range
  Low Voltage Range Supply: 2.7V to 3.6V (3.0V to 3.6V required for USB)
  Packages: SO28, PLCC52, VQFP64

  Tags:AT89C5131AL芯片解密  AT89C5131AL单片机解密

tags:AT89C5131AL

上一篇文章:AT89C5131AM IC解密

下一篇文章:AT89C1051U芯片解密

相关文章